Bizator  /  Adverts  /  equipment and materials  /  industrial equipment  /  wood-working machines

Trouser fuel briquettes 800 kg per hour. Poland.

Offer type: salePublished: 28.08.2017
Company:OOO Grandenergo
Show phone
Write a message
Address:Horad Polatsk, Republic of Belarus, Vitebsk Oblast
          Line for the production of fuel briquettes from waste wood and straw - Extruder VT"
a) 800 kg/h on the chips
b) 450 - 600 kg/h on the straw.
  The line includes:
- briquetting press 1 piece;
- charging the reservoir with viagrabestellen - 1 piece;
- guides briquette - 2 sets;
- remote control - 1 piece
Technical description line for the production of fuel briquettes
The extruder mechanical WT is used for the production briquette without the use of binders from the wood waste (chips, sawdust), as well as grain, rapeseed straw and other waste containing pulp (waste from flax, cotton, and the like). The fraction used raw materials must pass from 1 to 3 mm, and the moisture content of 8-15%. Raw materials can not be contaminated with such substances as: oils, lubricants, paints, varnishes, and mineral impurities, such as sand and the like should not exceed 1.5% by weight.
The output briquette has a cylindrical shape with a diameter of 60 mm and with a minimum length 30 mm, Given the nature of the work of the extruder, that is, circular push servings of raw materials, the output briquette represents much the compressed segments of length from 4 to 6 mm. In this regard, his Pets the break between segments. The length of the briquette makes from 30 to 300 mm Energy what is released during the combustion of the briquettes depends on raw material and the use of biomass makes from 16 to 19.5 MJ/kg
   Technical data:
- capacity of 800 kg/h (depends on the type of raw materials used); diameter of preform 50 or 60 mm;
- power supply 400 V 50 Hz; motor drive 22 kW 1430 rpm./min;
- motor vyhrabala 1.1 kW, 1430 rpm./min; motor drive screw 2x3 kW 1430 about./minutes
- the pressure is 0.1 to 0.7 MPa; capacity raw water tank 1,5m3; weight without raw tank about 2.2 t;
- the mass of the extruder with the commodity tank of about 3000 kg; remote control 600x600x200 mm;
- guides briquette 8, length 1 PCs = 1.5 m; - tank height 2.7 m (without cyclone);
- full length of the extruder together with the guides 8.9 m; - width of the extruder 1,4 m
Optionally, the length of the guides can be longer up to 3 m distance