Lift-lift for chandelier installation in the side of the axis of the lifting/lowering up to 454 kg ALL1000RM, Aladdin, USA

In the basic configuration, it is possible to connect only 1 light (one-button switch), the power of the connected lamps is no more than 2200 watts. As an option, it is possible to supply winches for chandeliers with the connector for connecting two lighting groups (dvuhklavishny switch), the power of the connected lamps 3300 watts.

The lift controls-lift for chandelier is provided by wall mounted panel by turning and holding the key. Additionally, it is possible to install smart block to set the final down position of the chandelier and connected via a "Smart home". As additional protection "child", panel aktiviziruyutsya turn of the key.To manage multiple lifts, it is possible to supply Multicontroller touch panel

Basic winch for the chandelier with a rope of 19.8 m. Optionally, it is possible to supply lift for chandeliers with a long rope of 27.4 m to 36.6 m.

For example in the base lift is used exclusively by the cable length 19.8 m, 1 cascade enable lamps 2200 W, control pan-tilt key from the wall panel (the key must turn and hold until the chandelier moves up or down).

We can put the lift in such a way that You will be able to increase the height of the ascent/descent of the chandelier to 36.6 m, set "smart panel" SMART, which will allow you to raise/lower the chandelier in the automatic mode, i.e. just by pressing the "up" or "down" (without retention), while this panel will allow you to remember the lower height of the descent of the chandelier to the lift is stopped automatically and the chandelier lay on the floor. Can also add your own Multicontroller that allows you to manage multiple lifts from a single dashboard.

Additionally can be equipped with a touch panel, with which it is possible to manage multiple lifts up To 16 units), as well as Relamping Cord om Determine which bulb needs to be changed, when the chandelier the chandelier is on the floor level with the help of the Relamping Cord. After removing one of the bulbs, insert the hex end of the cord into the socket. Connect the other end to the socket 220 V. Press the safety switch to temporarily Relight the chandelier to easily see which bulbs need to be replaced.

The installation of this hoist is possible on any surface, any height relative to the point of attachment of the chandelier. The estimated cost of installation and commissioning of the hoist for chandelier - 6000 UAH, excluding travel expenses for 2 installers.

Brand: ALADDIN

Country of origin: USA

Height: 19.8 m

Weight: 58 kg

Dimensions: mm 700х460х230

Load capacity: 454 kg

Max. long cable: 36,6 m