Guillotine shears NA
Offer type: salePublished: 17.10.2014
| Seller: |  Zajtsev Yurij Aleksandrovich |
| Phones: |  (48266)5-28-03 Show phone 903-803-83-16 Show phone |
| Address: | Russian Federation, Tverskaya Oblast' |
Guillotine shears, guillotines are designed for straight cutting of sheet and strip material. Guillotine shears are used in the procurement departments of the enterprises of mechanical engineering, shipbuilding and other industries.
On guillotine shears possible cutting of non-metallic sheet materials, eliminating dull and cracking of the edges of the knives. Base team with a fixed table on which a fixed set of knives. Knife beam is moved along the lateral roller supports, and in front of two flat rails. Cut the sheet at the time of cutting is pressed to the table with hydraulic clamps. Managing the scissors shears button and pedal. Mode: up, single and continuous stroke.
The complex also includes a feed device model UP, truck sliding model T6.
Specifications:
The largest dimensions of the cut sheet, mm
- width of 20
- width 3150
The greatest length of the cut strip on the plate 1000 mm
The frequency of moves of a knife (min-1)
auxiliary 30
- when cutting the longest dimension of the cut sheet 3,5
The tilt angle of the rolling knife 2 gr.10min.
Allowable cutting force, kN 950
The contact pressure of the sheet, kN 280
The moving speed of the rear stop, m/min 0-3,6
The air pressure in the network, MPa 0,45
Total power of electric motors, kW 27
The dimensions of the scissors without attached equipment, mm
from left to right 5100
- front to back 3550
- height above floor level 2760
Shears weight without extra equipment (kg) 27850
On guillotine shears possible cutting of non-metallic sheet materials, eliminating dull and cracking of the edges of the knives. Base team with a fixed table on which a fixed set of knives. Knife beam is moved along the lateral roller supports, and in front of two flat rails. Cut the sheet at the time of cutting is pressed to the table with hydraulic clamps. Managing the scissors shears button and pedal. Mode: up, single and continuous stroke.
The complex also includes a feed device model UP, truck sliding model T6.
Specifications:
The largest dimensions of the cut sheet, mm
- width of 20
- width 3150
The greatest length of the cut strip on the plate 1000 mm
The frequency of moves of a knife (min-1)
auxiliary 30
- when cutting the longest dimension of the cut sheet 3,5
The tilt angle of the rolling knife 2 gr.10min.
Allowable cutting force, kN 950
The contact pressure of the sheet, kN 280
The moving speed of the rear stop, m/min 0-3,6
The air pressure in the network, MPa 0,45
Total power of electric motors, kW 27
The dimensions of the scissors without attached equipment, mm
from left to right 5100
- front to back 3550
- height above floor level 2760
Shears weight without extra equipment (kg) 27850
