Guillotine shears NM
Offer type: salePublished: 17.10.2014
| Seller: |  Zajtsev Yurij Aleksandrovich |
| Phones: |  (48266)5-28-03 Show phone 903-803-83-16 Show phone |
| Address: | Russian Federation, Tverskaya Oblast' |
Guillotine guillotine shears crank with Kulichkova clutch-brake, designed for longitudinal and transverse cutting of sheet material.
Used in harvesting the shops of machine-building enterprises.
Guillotine shears guillotine is made with the top drive.
For dimensional strip cutting shears equipped with a rear focus, which is installed from the back side of knife beam.
The sheet when cutting guillotine cutting is pressed presser beam, working in unison with the cutter beam. A necessary condition of the clamp provide springs which are placed in the cups of the clamping beams.
The circuit provides the scissors gelatin on single and auto moves. Management of scissors Gallatin button and pedal.
Specifications:
The largest dimensions of the cut sheet, mm when GB=MP, mm, not more
- maximum 16
- minimum 2
- width 2000
The frequency of the strokes of the knife, in minutes, at least 20
The width of the cut sheet on the back fence 1000 mm
The number of cutting edges of the knife 4
The distance between the posts in the light, mm 2375
The highest cutting force, kN 800
The tilt angle of the rolling knife 2 deg 10 min
The contact force, kN 48
Current mains AC three phase
Frequency, Hz 50
Voltage, V 380
The dimensions of the scissors, mm
From left to right 2275
- Front to back 3150
- Height above floor level, mm 2350
Shears weight, kg 11000
Used in harvesting the shops of machine-building enterprises.
Guillotine shears guillotine is made with the top drive.
For dimensional strip cutting shears equipped with a rear focus, which is installed from the back side of knife beam.
The sheet when cutting guillotine cutting is pressed presser beam, working in unison with the cutter beam. A necessary condition of the clamp provide springs which are placed in the cups of the clamping beams.
The circuit provides the scissors gelatin on single and auto moves. Management of scissors Gallatin button and pedal.
Specifications:
The largest dimensions of the cut sheet, mm when GB=MP, mm, not more
- maximum 16
- minimum 2
- width 2000
The frequency of the strokes of the knife, in minutes, at least 20
The width of the cut sheet on the back fence 1000 mm
The number of cutting edges of the knife 4
The distance between the posts in the light, mm 2375
The highest cutting force, kN 800
The tilt angle of the rolling knife 2 deg 10 min
The contact force, kN 48
Current mains AC three phase
Frequency, Hz 50
Voltage, V 380
The dimensions of the scissors, mm
From left to right 2275
- Front to back 3150
- Height above floor level, mm 2350
Shears weight, kg 11000
