Guillotine shears NA
Offer type: salePublished: 17.10.2014
| Seller: |  Zajtsev Yurij Aleksandrovich |
| Phones: |  (48266)5-28-03 Show phone 903-803-83-16 Show phone |
| Address: | Russian Federation, Tverskaya Oblast' |
Shears, guillotines are designed for straight cutting of sheet and strip material. Used in harvesting the shops of machine-building enterprises.
On the scissors, guillotines for cutting the possible cutting of non-metallic sheet materials excluding dull and cracking of the edges of the knives. Base team with a fixed table on which a fixed set of knives. Knife beam is moved along the lateral roller supports, and in front of two flat rails. Cut the sheet at the time of cutting is pressed to the table with hydraulic clamps. Management scissors button and pedal. Mode: up, single and continuous stroke.
Guillotine model NA are the main technological units of equipment for cutting sheet ACNE. The complex also includes a feed device model UP, truck sliding model T6.
Specifications:
The largest dimensions of the cut sheet, mm, GB=500 MP, mm, not more
- maximum 6.3
- minimum 1
- width 3150
The greatest length of the cut strip on the plate 630 mm
The frequency of the strokes of the knife, min
auxiliary 60
- when cutting the longest dimension of the cut sheet 20
The angle of the movable knife 1 gr. 30 minutes
Allowable cutting force, kN 225
The contact pressure of the sheet, kN 76
The moving speed of the rear stop, m/min 0-3.6
The air pressure in the network, MPa 0.45
Total power of electric motors, kW 10.35
The distance from the floor level to the top of the knife 800 mm
The distance between the posts in the light, mm 3200
The dimensions of the scissors without attached equipment, mm
- 1680 from front to back
from left to right 4220
- height 1720
Shears weight without extra equipment (kg) 7200
On the scissors, guillotines for cutting the possible cutting of non-metallic sheet materials excluding dull and cracking of the edges of the knives. Base team with a fixed table on which a fixed set of knives. Knife beam is moved along the lateral roller supports, and in front of two flat rails. Cut the sheet at the time of cutting is pressed to the table with hydraulic clamps. Management scissors button and pedal. Mode: up, single and continuous stroke.
Guillotine model NA are the main technological units of equipment for cutting sheet ACNE. The complex also includes a feed device model UP, truck sliding model T6.
Specifications:
The largest dimensions of the cut sheet, mm, GB=500 MP, mm, not more
- maximum 6.3
- minimum 1
- width 3150
The greatest length of the cut strip on the plate 630 mm
The frequency of the strokes of the knife, min
auxiliary 60
- when cutting the longest dimension of the cut sheet 20
The angle of the movable knife 1 gr. 30 minutes
Allowable cutting force, kN 225
The contact pressure of the sheet, kN 76
The moving speed of the rear stop, m/min 0-3.6
The air pressure in the network, MPa 0.45
Total power of electric motors, kW 10.35
The distance from the floor level to the top of the knife 800 mm
The distance between the posts in the light, mm 3200
The dimensions of the scissors without attached equipment, mm
- 1680 from front to back
from left to right 4220
- height 1720
Shears weight without extra equipment (kg) 7200
