Sell the installation of applying a film of photoresist of ARM

Installation of ARM is designed for applying a film of photoresist on procurement of printed circuit boards or other flat items and is an integral part of the complex of equipment for the manufacture of printed circuit boards application of dry film photoresist.

The basis of installation is a method of simultaneous bilateral layup heated to a certain temperature of the film of photoresist on pre-prepared blank PCB with rubber rollers.

On the frame installation fasten all nodes and the mechanisms. For visual monitoring of processes inside the unit, and for filling bobbins film photoresist in front and rear walls of the frame provides quick frame from plexiglass.

To ensure the safety of the operator in the upper part of the frame has a socket for connection to an exhaust ventilation.

A box for storing reels of film photoresist located in the lower part of the frame and freely extends and retracts on rails framework. In the side walls of the box are six grooves, set the axis of the reels of film photoresist.

The stand is a welded construction made of square tubes and profiles.

For feeding blanks printed circuit boards from the front to the frame is attached to the feed table, which moves the bounding line, serving for field definition download one or more blanks printed circuit boards.

Rear bracket receiving table to accommodate blanks printed circuit boards coated with photoresist film.

Inside a skeleton is a system of shafts, ensuring the application of dry film photoresist simultaneously on both sides of the PCB. Provided by the shaft for winding peelable film from the photoresist polyethylene film.

For the bonding of the film with photoresist the foil surface of the dielectric photoresist when layering heats up. The heaters are located in the areas of application and are a housing original section, providing a uniform the distribution of heat. Inside the buildings, heaters and thermocouple.

On receiving the pay table with a photoresist received after regressi film photoresist with a special knife made of nichrome wire.

The electrical installation consists of remote control and control panel, which provide integration and disabling mechanisms, and monitoring them during operation.

On the control panel located on the front part of the frame, are the power switch setup button to activate the heaters, knife, switch to reverse the motor, the controller changes the speed rotation of the motor, millivoltmeters for automatic adjust the heating temperature of the heaters.

The control panel is located in a separate compartment in the bottom area of the frame. It installed electrical equipment, ensuring the functioning electric circuit installation.