Collectors Danfoss FHF-10 for 10 circuits

Manifold FHF is used for regulating the flow of coolant in the radiator systems and Underfloor heating. The pipeline each loop radiator or floor heating connected to a separate pair of connecting fittings dispenser that allows you to adjust the flow of coolant, and hence the heat capacity of the system in each building individually. The dispenser consists of the supply and return manifolds. The feed manifold has the ability to disable each of the circuits of the system and can be equipped with rotameters (series FHF-F). Reverse manifold equipped with built-in valve with pre-setting bandwidth, which allows to provide optimal hydraulic balancing of the system. For mount collectors, you must use brackets (FHF-MB), which are supplied separately. To release the air from the system you have to use automatic (FHF-EA) or manual (FHF-EM) radiators. You can also purchase sets of headers, consisting of the supply and return of collatoral, brackets (FHF-MB) and two automatic air vent (FHF-EA). To control the contour of the floor heating valve can be equipped with thermoelectric drive or thermostatic element in direct action with an external temperature controller. When using thermoelectric actuator control signal is received from the room thermostat depending on the needs of the room in heat. The valves are produced with a number of taps from 2 to 12. To increase the number of taps, the collectors can be connected in series with a set of nipple FHF-C, ordered separately. Ball valves (FHF-BV) to disable the dispenser also ordered separately as an accessory.