Bizator  /  Adverts  /  equipment and materials  /  industrial equipment  /  compressors, pumps, compressor equipment

valve CPC-110-3,0

Offer type: salePublished: 16.11.2018
Company:Torgovyij Dom 'KMZ'
Seller:Torgovyij Dom 'KMZ' Kristina Aleksandrovna
Show phone
Write a message
Address:Mykolayivs'ka Oblast', Mykolayiv, Ukraine

After receiving valves before you install them onto the compressor, the valves are subjected to external (visual) inspection for damage during transportation. After inspection the valves are blown with compressed air, pressure of not less than 0.05 Mn/m -2 (0.5 kgf/cm -2 ). In the assembled valve checking freedom of movement of the plates and springs in cracks in the valve housing and secure the locking straps. The movement of plates and springs, checked the outlet side of the gas (side A) and may be performed by a tool that provides the preservation of the integrity of the plates and springs. Since each valve CTC (valve PKC) can serve as the suction and discharge valve, it is necessary to closely monitor the correct setting it in the mounts of the compressor cylinder. The suction valve should be to set the socket side of the gas outlet - And discharge - side of the gas inlet - B (1). The installation of the valves in the nest produce without bias, paronitovye or asbestos gasket.