Booth M-A
Offer type: salePublished: 22.08.2018
| Seller: |  Netunaev Andrej |
| Phones: |  (34369) 47351 Show phone 47751 Show phone |
| Address: | Berezovskiy, Russian Federation, Sverdlovskaya Oblast' |
Stands , M-E designed for test and adjustment of automotive injectors of diesel engines, mobile diagnostic units, and allow you to check the following settings:
M-A checks the pressure at the beginning of injection;
The quality of fuel atomization;
The tightness of the shut-off cone;
The density of the spray-on shut-off cone and the cylindrical part (time pressure).
In the stands there is a direct fuel line to check the vibration of the needle and the sound characteristics of the nozzle. Measuring stand M-A - precision pressure sensor and displayed on the display of the electronic unit. Similar happens on the bench for repair of the pump.
The range of the reproduced pressure, MPa (kgf/cm2) 0...40 (0...400)
Capacity for fuel, l not less than 2
The fuel supply mm3/cycle, not less than 1200
The cost bub.
M-A checks the pressure at the beginning of injection;
The quality of fuel atomization;
The tightness of the shut-off cone;
The density of the spray-on shut-off cone and the cylindrical part (time pressure).
In the stands there is a direct fuel line to check the vibration of the needle and the sound characteristics of the nozzle. Measuring stand M-A - precision pressure sensor and displayed on the display of the electronic unit. Similar happens on the bench for repair of the pump.
The range of the reproduced pressure, MPa (kgf/cm2) 0...40 (0...400)
Capacity for fuel, l not less than 2
The fuel supply mm3/cycle, not less than 1200
The cost bub.
