Bizator  /  Adverts  /  petrochemical production  /  chemical products

Secondary polymers: LDPE 15803 1st grade, HDPE 277, 273, PS polystyrene, PP secondary

Offer type: salePublished: 12.04.2019
Company:FOP Korbachkov M.I
Seller:Anastasiya Aleksandrovna
Show phone
Write a message
Address:Kyiv, Ukraine
Enterprise on processing of polymers is constantly offering washed secondary granule:

1. Secondary granule HDPE for blow molding products. Q: 0,3-0,6 gr. / 10 min (190/2,16) Color: blue, white, black, etc.
Used for the manufacture of bottles, containers large volumes. Made from waste bottles, barrels, cans.
2. Secondary granule HDPE injection molding. The PTR: 6-9 gr. / 10 min (190/2,16) Color: red, green, blue, black, etc.
Used for the production of household goods, goods for garden and kitchen garden technical details, piping details etc. Made from clean waste household, drawer, products.
3. LDPE recycled granule. Analogue LDPE 158 grade. MFR: ~2 g. / 10 min (190/5) Color: transparent.
Is used for the production of films, packages, extruded and izledi by casting (household goods, etc.).
Made from clear polyethylene primary waste (mainly the primary film).
4. Analogue LDPE 102 stamps. Q: 0,3 gr. / 10 min (190/5) Color: transparent. It is used for manufacturing pipes, fittings, blown products of large capacity, for films and film products for General purpose.
Made from clear polyethylene primary waste (mainly the primary film).
5. Pipe composition LDPE+HDPE. Q: 0,7-1,8 gr. / 10 min (190/5) Color: black, dark grey. Used for making pipe, plastic irrigation hose, furniure. Made primarily from a mixture of LDPE and HDPE.
6. High-impact polystyrene (PS, HIPS), analogue of 508. The melt flow index at 200 °C for 5 kg load: 7,5±1,5 g/10 min, softening Temperature for Vika: not less 84,0 °C
High impact polystyrene for the manufacture of products by molding under pressure. Has the ability to molding with accelerated cycle, while maintaining the impact strength is Intended for the manufacture of structural foam and products such as housings of household appliances, toys and articles requiring high gloss.
7. Secondary PP (PP), polypropylene extrusion; injection molding polypropylene.
In future it is used for the manufacture of hotruby and other household goods. This recipe is a melt flow of 4-8 g/10min. We manufacture PP suitable for production of the final plastic products by extrusion and molding pressure.

Besides the obvious environmental benefits to society and humanity, recycling and use of recycled LDPE, HDPE, composites, and other polymeric materials has a transparent economic meaning. It is very profitable. The value of the secondary granules of LDPE, HDPE, polypropylene, typically at 40-60% below market value primary granules. As for ABS, polystyrene, secondary granule can be 30-50% cheaper than the primary granules.